华为UPS电源需要注意哪些事项

华为UPS电源需要注意哪些事项

一、安装设置 设备间隙：考虑到维修和适当的通风，各种规格的机柜需要以下间隙：
（1）距侧板： 15.2cm
（2）顶部和后部： 30.5cm
（3）前面： 91.5cm
二位置要求： 要将Powerware 9170 UPS与其保护的负载设备或配电盘尽可能近地安装。如果附加的Powerware 9170电池位于独立的电池柜中，则外部电池柜的位置应尽可能靠近。
除了给大家讲解关于华为UPS电源的安装，我还准备给大家讲解关于电器安装：
1、带有维修旁路开关的典型安装：
输入电源可通过电路硬连线到电源断路器或选配的外部旁路开关上。对于硬连线安装，建议您安装Powerware维修旁路开关，在维修或UPS停机期间能够转换电源。如果使用了旁路开关，则UPS输入和UPS输出必须通过单独的电路硬连线．
2、没有维修旁路开关的典型安装：
3、输入电流额定值：
掌握好了这些安装的要领，你在安装过程中就不会出现差错，这样就可以使你的三科UPS电源能够得到很好地发挥。有利于其寿命的延长。

HUAWEI UPS power needs to pay attention to what matters.

1. Installation of equipment clearance: In view of maintenance and appropriate ventilation, various specifications of cabinets need the following clearance:

(1) from side panel: 15.2cm

(2) top and rear: 30.5cm

(3) front: 91.5cm

Two position requirements: Powerware 9170 UPS should be installed as close as possible to the load equipment or distribution panels it protects. If the additional Powerware 9170 battery is located in a separate battery cabinet, the external battery cabinet should be located as close as possible.

In addition to explaining the installation of the three-branch UPS power supply, I'm also going to explain the installation of electrical appliances:

1. Typical installation with maintenance bypass switch:

The input power can be hard wired through the circuit to the power circuit breaker or the optional external bypass switch. For hard-wired installation, it is recommended that you install Powerware Service Bypass Switch to convert power during maintenance or UPS downtime. If a bypass switch is used, the UPS input and the UPS output must be hardwired by a separate circuit.

2. Typical installation without servicing bypass switches:

3. Input current rating:

Master the essentials of these installation, you will not make mistakes in the installation process, so that you can make good use of the three UPS power supply. Is conducive to the extension of their life span.